Genset canopy louvre panel design: tolerances and DFM
Louvre free area, blade pitch, acoustic loss and the welding that stops blade rattle, with the tolerances a genset canopy panel should carry.
Read
Manufacturing guides
Sheet metal manufacturing guides
The engineering behind stamped, laser-cut, formed, welded and coated parts: tolerances, tooling, coating failures and what a drawing needs before it can be quoted. Written and reviewed inside the Ganesh plants.
All guides, page 4
Browse the full library.
Data centre wall-mount rack design: DFM, loads and tolerances
Data centre wall-mount rack design for 6U to 18U cabinets: cantilever anchor loads, back-plate stiffness, door swing, thermal limits and coating for earthing.
Read
Railway underframe bracket manufacturing: plate to galvanised
How a railway underframe bracket is made in 6–12 mm IS 2062 plate: hole patterns, fillet welds, distortion control, galvanising vents and the release file.
Read
Data centre rack mounting rail design: tolerances and DFM
Data centre rack mounting rail design for 19-inch racks: the 465.1 mm and 44.45 mm numbers, bend deductions, cage-nut holes, coating allowance and load reality.
Read
Genset acoustic enclosure design guide: tolerances and DFM
DFM rules for a genset acoustic enclosure: panel gauges, louvre free area, door seals, bend radii, realistic tolerances and the leaks that cost 10 dB(A).
Read
Elevator counterweight frame design guide
How to size, detail and manufacture an elevator counterweight frame: balance weight, filler stack, tie rods, shoe brackets, tolerances and coating allowance.
Read
Elevator rail clip and fishplate bracket design guide
Slot sizing, clamp length, bolt preload and coating choice for elevator rail clips and fishplate brackets, with the joint tolerances that hold rail alignment.
Read
Elevator handrail manufacturing: forming, welding, finish
How an elevator handrail is formed, welded and finished, with the bracket pitch, grip geometry and weld-finish rules that keep a car handrail rigid and clean.
Read
Genset cable entry panel design: DFM and tolerances
Gland plate thickness, hole spacing, gasket compression, earthing and the acoustic seal that keep water and noise out of a DG set canopy.
Read
Go from reading to checking
The guides follow the same questions as the free tools. Size a press, check a bend, estimate a cut part or build the RFQ pack.
Every article is reviewed by the Ganesh engineering team. See the RSS feed or browse capability pages by market.